The solution for Hot Air Seam Sealing Machine tape often running over the tight side

- Jun 18, 2020-

For the adhesive tape of Hot Air Seam Sealing Machine often running over the tight side, it is recommended to deal with the following methods:

1. Adhesive machine with automatic adjustment mechanism, when appeared partial it can automatically adjust.

2. If found to be dysfunctional, the control panel deflection switch can be turned off, cut off the power supply, the side wall panel inside the upper and lower handles are clockwise rotating 100 degrees, so that the umbrella gear out of meshing, close the electrical door, after the total power supply, you can use manually.

3. If the upper and lower tape offset position is not normal, which can also use the above method to make the umbrella gear meshing out, rotate the glue handle, change the relative meshing position of the umbrella gear and adjust.

4. Reset the upper and lower handles and the deflection switch is closed again to restore auto-biasing.

The main causes for tape bias of Hot Air Seam Sealing Machine are the following:

1. The adjustment mechanism umbrella gear stop screw is loose.

2. The deflection circuit board is faulty.

3. The deflection switch is not working or the lead is out of order.

4. After manual adjustment, the deflection roller position is too skewed.

Hot Air Seam Sealing Machine


Here's the solution for Hot Air Seam Sealing Machine :

1. Tighten the adjustment mechanism umbrella gear stop screw.

2. Repair or replace the deflection circuit board.

3. Repair or replace the deflection switch and check the lead.

4. Restore manual adjustment and readjust the position of the deflection roller.

Tape seriously run off, which will lead to the limit switch work, it will cut off the control line power supply, so that the main motor stop working, resulting in the machine can not work, pay attention to it.


If you want to know us, please contact: wym@eagleco.cn

Previous:What is a Fully Automatic Face Mask Cutting Machine? Next:Solutions to Common Problems of Hot Air Seam Sealing Machine